C 1000S
Condenser Microphone
Description
The AKG Model C 1000 S gradient condenser microphone
uses a low noise pre-polarized backplate (electret) and is
ideal for a variety of recording and sound reinforcement
applications. Its polar pattern can be quickly converted from
cardioid to hypercardioid by placing an acoustical converter
over the end of the microphone capsule; this has virtually no
effect on the on-axis response of the microphone. The on-
axis response of the C 1000 S has a gentle (-6 db/octave)
roll-off below 200 Hz which has been tailored for the normal
close-in use of cardioid and hypercardioid microphones in
studio recording and sound reinforcement applications. The
microphone may thus be used in close-in application with no
need for further equalization. The C 1000 S may be powered
by a 9-volt battery or by phantom powering over a range
from 9 to 52 Vdc. The included PPC 1000 Polar Pattern
Converter allows quick changeover from cardioid to
hypercardioid. A silent on/off switch is recessed to prevent
inadvertent shut-off. The included Presence Boost Adapter
piece PB 1000 creates an emphasis of the higher frequencies
from 5 to 9 kHz by about 3 to 5 dB, which not only improves
the transmission of sibilances but may be also advantageous
when recording instruments requiring greater high frequency
content in their audio spectrum.
Specifications
Transducer Principle: Gradient pre-polarized
condenser
Frequency Response: 50–20,000 Hz (see family of
Features
response curves)
Polar Pattern:
Cardioid or hypercardioid
• Extended low and high frequency
response, tailored for close
Equivalent Noise Level: 20 dB-A
^
Sensitivity at 1,000 Hz: 6 mV/Pa = -45 dBV
Sound Pressure Level at 1% THD:
proximity to sound sources
137 dB (145 dB for 3% THD)
• Operates on 9 volt battery or
phantom power (9 to 52 Vdc)
• High acoustic level capability
(137 dB-SPL for 1.0 % THD)
S/N Ratio (A-weighted): 74 dB
Electr. Impedance:
Load Impedance:
Power Requirement:
≤ 200 ohms
≥ 2,000 ohms
Phantom powering, nominal
9-52 Vdc or 9 V battery
• PPC 1000 – Polar Pattern Converter
from cardioid to hypercardioid polar
pattern
• PB 1000 – Presence Boost Adapter
for increased intelligibility +3 to 5 dB
at 5 to 9 kHz
Connector:
Finish:
3-pin XLR type
Matte dark gray metallic enamel
Size:
Dia 1.3 in. (39 mm),
Length 8.7 in. (220 mm)
Net/Shipping Weight: 9.7 oz. (276 g)/1.8 lbs. (820 g)
Included Accessories: SA 43 Stand adapter
W 1000 Windscreen,
PPC 1000 Polar pattern converter
PB 1000 Presence boost adapter
Optional Accessories: N 62 AC Power supply
|
AEG Microwave Oven MC_170 User Manual
AEG Microwave Oven MCD1751E User Manual
Amana Dishwasher L0503010 User Manual
Amana Refrigerator ARS2364AB User Manual
American Standard Indoor Furnishings M968412A User Manual
Audiovox Satellite Radio 093BPR User Manual
Audiovox Stereo Amplifier JPA460 User Manual
Audiovox Stereo System K 13 User Manual
Axor Plumbing Product 04195000 User Manual
Eureka Tents Tent Scenic Pass 2 User Manual